Factorytalk Activation Crack

Factory Talk Activation LIVE PLC Questions And Answers.

• Rockwell Automation Factorytalk Activation

When FactoryTalk Activation (FTA) was first released, many clients expressed reservations about moving to it. For some it was the fact that the older “Floppy Master Disk” activation would allow the use of the original “Master Disk” as a back-up activation in case the movable activation file was lost or corrupted. To address this, in CPR9 Rockwell added a FactoryTalk Activation “Grace Period” mode into software products which used FactoryTalk activation. This “Grace Period” allowed customers to install and run the software on a new PC for up to seven days without activation. In an emergency situation, if the client's PC crashed and they were in a remote location without the ability to contact Rockwell's activation group for a reset, this “Grace Period” mode gave them a temporary solution to get back up and running quickly.

To utilize the “Grace Period,” clients install their Rockwell Software on a new PC (or virtual machine) that has not previously had the software in question running in “Grace Period” mode. Note that during installation some multi-version products, like RSLogix 5000, do require a valid serial number to run in “Grace Period” mode in the desired version (i.e.

Pro, Full, Mini.) When the software is launched for the first time without activation, the client will be greeted with a pop-up window stating, “The product has not been activated but will continue to run in a grace period for seven days.” This seven day period is from the moment this pop-up first appears, and even if the software is not launched again during this period it will still expire exactly seven days later. The “Grace Period” is also not resettable by changing the PC's clock back in time, as once the seventh day triggers the end of the “Grace Period” the software will no longer run in “Grace Period” mode no matter how the PC clock is manipulated. Once the “Grace Period” ends, a second popup will be displayed upon subsequent launching of the software.

It reads, “Failed to activate (product name.) The grace period has expired.” For those products without a demo mode (like RSLogix) you'll be asked to activate the product and if you chose not to the product will not launch. For those products with a demo or free mode (RSView, RSLinx) the software will start in that mode. If you activate the software after the “Grace Period” has expired you'll be greeted with a third pop-up which reads, “This product has been activated.

The grace period has ended for (product name.)” The software should now run with the features enabled by the activation used. You can also find the pop-ups window messages described above in Rockwell's Diagnostic viewer. This software is found in the Start Menu under FactoryTalk Tools. Below I'll paste in three screen shots of Diagnostic viewer messages which correspond to the pop-up windows mentioned above: For more information about Rockwell Software's “Grace Period” mode, please reference these public Rockwell technotes:.

I hope the above information about Rockwell's “FactoryTalk Activation Grace Period mode” was helpful. If you have a comment on this article please click on the “post a comment or question” link below. Sincerely, Automation and If you enjoyed my article, you may like my courses.

I started a new thread for this subject. I just tried this.

I went to the Rockwell Automation site / Activation support /Get new activations Host ID Type - Hard Drive Serial Number Host ID - f07d60b1 Serial Number ( RS Trainer Software) - Product Key ( RS Trainer Software) - DRX36-YKBNN When I click next, I am getting this. No installs are available for this Serial Number and Revision.

Rockwell Automation Factorytalk Activation

I have the software installed. FYI, Rockwell sent me a e-mail with a a.lic. # Rockwell Software Activation File # Copyright (c) 2010 Rockwell Automation Technologies, Inc.